強化亞克力油墨：

適用于強化亞克力,硬化pmma,強化pc,強化pet,亞克力電鍍表面印刷,油墨印刷性能好,固化后對極性底材具有優異的附著力,超越精工hac油墨質量,相同品質超低價格。溫度80-90℃,30~40分鐘實干；印刷方便,可以絲印和移印！詳

油墨技術參考

粘度：6000-15000cps（因溫度,顏色而異）

細度：5um↓

附著力：5b優

80-90℃時,30-40分鐘完全固化

過網性能：200目-400目網紗（用金,銀,珠光粉  調配之油墨除外）

稀釋劑  ：s90中干水

涂覆面積：30-35㎡/㎏（測試以300目聚脂單絲感光膠,網版為標準）

固化劑  ：h1

油墨使用方法

應與ols系列固化劑  配合使用（油墨：固化劑  ≈90：10）。

使用前應與ols固化劑  按既定比例充分攪拌10分鐘。

根據需要可添加10-30％稀釋劑  進行稀釋。

受到污染的素  材應在表面用去漬油清洗或擦拭,以利于印刷效果優異。

印刷錯誤時,應待其未完全干燥前用抹字水去除,重新再印。

印刷過程中遇到網版堵塞之狀況,應先用洗版水清洗之后再印刷。

需要套色時,應在前顏色表干或硬干后再進行套色工作。

附著力,硬度,耐酸  性,耐油性,耐去漬油性,抗劃傷性,耐磨性等性能的檢測,需要墨層完全固化后方可檢測。

未經允許,不得將ols系列油墨與其它類型油墨混用及配色。

注意事項

使用前添加適量稀釋劑  充分攪勻。

不同型號的油墨請用專用稀釋劑  。

試印確認符合要求后再批量生產。

做好被印物的表面清除油脂及雜質工作,以促進附著效果。

絲網或被印物表面帶靜電,將會造成印刷后油墨會有細孔。

環境濕度過高會影響印刷效果。

制品涂層實干后,方可疊層裝運。

作業完畢后剩余油墨緊閉容器封口。

當印刷品質出現不良狀況時,請向本公司技術部咨詢,切勿自行處理。

安  全規劃

油墨,稀釋劑  使用及儲存時嚴禁煙火。

使用時注意施工場所的通風狀況良好。

盡量避免皮膚直接接觸。

本品不慎濺入口,鼻,眼,耳內,應用大量水清洗或直接求助醫  生。

對本品過敏者,使用前應涂覆一層皮膚護膚膏或戴不滲透性手套。

strengthen acrylic ink:

applicable to strengthen acrylic, hardened pmma, enhanced pc, enhanced pet,acrylic plating surface printing ink, printing performance is good, after the curing ofpolar substrate with excellent adhesion, beyond the seiko hac ink quality, the same quality of ultra low price. the temperature of 80-90 deg c for 30~40 minutes of action;printing, convenient, can screen printing【敏感詞】pad printing! detailed

technical reference ink

viscosity: 6000-15000cps (due to temperature, color varies)

fineness: 5um down

excellent adhesion: 5b

80-90 c, 30-40 minutes to complete curing

net performance: 200 -400 mesh screen (with gold, silver, pearl powder【敏感詞】the deployment of ink except)

thinner: dry water s90

coating area: 30-35 square meters / kg (test with 300 mesh polyester monofilamentphotoptic gum, screen as standard)

curing agent: h1

ink using method

should be used in conjunction with the ols series curing agent (ink: curing agent is 90:10).

before use【敏感詞】ols curing agent in certain proportion【敏感詞】fully stirring for 10 minutes.

according to the need to add the 10-30％ diluent dilution.

the contaminated material should be clean【敏感詞】wipe with a cleaning oil on the surface, in order to facilitate the printing effect is excellent.

printing error, should wait for its not completely dry before use wipe the word waterremoval, re printed.

meet the status screen clogging in the printing process, should be after the first wash with water clean version printing.

need to register, should be in before the color table dry【敏感詞】hard after the register work.

adhesion, hardness, acid resistance, oil resistance, resistance to stains oily, scratch resistance, abrasion resistance【敏感詞】other properties of the detection, require ink layer completely cured before detection.

without permission, may not be ols series of ink【敏感詞】other types of ink mixing【敏感詞】matching.

the matters needing attention

before use, add appropriate amount of diluent stirring.

different types of ink please use special thinner.

try printing again after confirmation of compliance with the requirements of mass production.

do be print surface to remove grease【敏感詞】impurities, in order to promote the adhesion effect.

the screen【敏感詞】by print surface with static electricity, will result in printing ink after printing will have pores.

environmental humidity is too high will affect the printing effect.

products after the coating work, can be laminated shipment.

when the operation is completed the remaining ink closed container sealing.

when the printing quality of the bad situation, please refer to the technical departmentof the advisory company, do not dispose of.

safety planning

ink, fireworks is strictly prohibited the use of thinner【敏感詞】storage.

when used to note the construction site of the good ventilation conditions.

avoid direct contact with skin.

this product is inadvertently splashed entrance, nose, eyes, ears, use a large number of water washing【敏感詞】direct help doctor.

those who are allergic to this product, coated with a layer of skin【敏感詞】skin care cream【敏感詞】wearing impermeable gloves before use.